Introduction

This document provides instructions for setup and examples of the Optifacts Tray Track custom configurations.

Procedure

From the Optifacts main menu:

Select Option 3 - Editor Utilities and press Enter.

Select Option 6 - Configuration Editor and press Enter.

Select Option 6 – Edit Custom Configuration and press Enter.

The Custom Configuration Editor displays.

Press “Q” to Query

Ensure that the table below exists. If the table does not exist:

Press “A” to add a new record.
Enter all the information as required.
- Calling Program - Name of the program called to use this configuration. (i.e., STARTUP, TRACK, LAYOUT, EOE, DAEMON, GEN INTRFC, GENERATOR, INVENTORY, TRALLAR, etc.)
- Field Name - Is unique, but some configurations must start with a prefix such as INTERFACE or other.
- Enabled (Y/N) - Y
- Character Setting - Optifacts program and interface port information
- Float Setting - Enter applicable data, such as a lite-up num or other dependent on the type of configuration.
- Integer Setting - Enter applicable data, such as a lite-up bit or other dependents on the type of configuration.
- Comment - Description of the interface

The settings above may vary by the lab and are dependent on what is being configured. Check with your lab administrator, manager, or support for the correct port and setting values.