Introduction
his This document provides instructions for the Frame Trace and Frame to Come Lookup process when the frame trace is done before the job has started.
Procedure
Verify that Auto-assign Bin is Turned on
The following custom configuration must be enabled.
Image Removed
Image Added
Job without Frame
- Job is The job gets keyed as normal without the Frameframe.
- Work Ticket is gets set aside until the Frame frame arrives.
- Frame box comes from the Doctor and gets sorted in the Frame Room.
- Frame Room goes into 7-17 and “checks in” the Frame.
- Label is The label gets printed and placed on the bag/box/case
- Frame is The frame gets sent to the Tracer
- New Work Ticket is gets printed, and the job is started.
- Checked-in Frames are get sent to the Frame Manager.
Job with Frame
- Job is keyed as normal.
- Frame Room or Rx OE goes into Frame to Come Lookup menu 7-17 and “checks in” the Frame.
- Label is The label gets printed and placed on bag/box/case
- Work Ticket is gets sent to the Tracer.
- Lenses are picked and sent into the surface .department
- Frames are get taken to Frame Manager.
Frame Manager
- Frame and Lenses “Married” after the job is done in Surface/AR using scanning protocol.
- Refer to the Frame Marry document for full instructions.
- Job moves on to the Finishing department.
To view and download these instructions as a PDF file, click on the following document image.
| View file |
|---|
| name | Frame Trace Before Job Start.pdf |
|---|
| height | 250 |
|---|
|
