Introduction
This document provides instructions for managing a job where the Frame Trace and Frame to Come Lookup process when the frame trace is done before the job is has started in order entry.
Procedure
Verify that Auto-assign Bin is Turned on
The following custom configuration must be enabled.
Image RemovedImage Added
Job without Frame
- Job is The job gets keyed as normal without the Frameframe.
- Work Ticket is gets set aside until the Frame frame arrives.
- Frame box comes from the Doctor and gets sorted in the Frame Room.
- Frame Room goes into 7-17 and “checks in” the Frame.
- Label is The label gets printed and placed on the bag/box/case
- Frame is The frame gets sent to the Tracer
- New Work Ticket is gets printed, and the job is started.
- Checked-in Frames are get sent to the Frame Manager.
Job with Frame
- Job is keyed as normal.
- Frame Room or Rx OE goes into Frame to Come Lookup menu 7-17 and “checks in” the Frame.
- Label is The label gets printed and placed on bag/box/case
- Work Ticket is gets sent to the Tracer.
- Lenses are picked and sent into the surface .department
- Frames are get taken to Frame Manager.
Frame Manager
- Frame and Lenses “Married” after the job is done in Surface/AR using scanning protocol.
- Refer to the Frame Marry document for full instructions.
- Job moves on to the Finishing department.
To view and download these instructions as a PDF file, click on the following document image.
View file |
---|
name | Frame Trace Before Job Start.pdf |
---|
height | 250 |
---|
|