Anchor

	top
	top

Search Optifacts User Documentation

Live Search

spaceKey	OPPUB
placeholder	Enter search keyword(s) here

Table of Contents (on this page)

Table of Contents

indent	20px
style	Bullet

Introduction

This document provides instructions for managing a job where the frame trace is done before the job is started in order entry.

Procedure

The following custom configuration must be enabled.

Refer to the Custom Configuration section in the Frame Management Setup (Frame to Come/Frame Marry/Label Printing) document for full instructions.

Job is keyed as normal without the Frame.
Work Ticket is set aside until the Frame arrives.
Frame box comes from the Doctor and sorted in Frame Room.
Frame Room goes into 7-17 and “checks in” the Frame.
- Refer to the Frame Bin Assignment Before Order Entry document for full instructions.
Label is printed and placed on bag/box/case
- Refer to the Label Printing section in the Frame Management Setup (Frame to Come/Frame Marry/Label Printing) document for full instructions.
Frame is sent to the Tracer
New Work Ticket is printed and the job is started.
Checked in Frames are sent to the Frame Manager.

Job is keyed as normal.
Frame Room or Rx OE goes into Frame to Come Lookup menu 7-17 and “checks in” the Frame.
- Refer to the Frame Bin Assignment Before Order Entry document for full instructions.
Label is printed and placed on bag/box/case
- Refer to the Label Printing section in the Frame Management Setup (Frame to Come/Frame Marry/Label Printing) document for full instructions.
Work Ticket is sent to the Tracer.
Lenses are picked and sent into surface.
Frames are taken to Frame Manager.

Frame and Lenses “Married” after the job is done in Surface/AR using scanning protocol.
- Refer to the Frame Marry document for full instructions.
Job moves on to Finishing