Search Optifacts User Documentation
Table of Contents (on this page)
Introduction
This document provides instructions for setting up ...
Procedure
Configuring Tray Track Scanner / Bar Code Reader
This section assumes your scanner/reader is already programmed to work with Optifacts Tray Track. Optifacts Support will assist with configuring your scanner if needed.
This Quick Note configures the stations you can scan with a given scanner/reader.
This applies to scanners attached to the Job Track interface only; it does not apply to scanners connected to a terminal.
- From the Main Menu, select #7 - Tray Track
- Select option #12 - Tray Track Configuration
- Select option #3 - Reader ID & Station ID/Number Setup
- Press 'a', 'b', 'c' or whatever letter has been designated for the reader you are about to update.
- Enter the Sub-Master Station Number you want to add. As soon as this number is entered, the description for the number will be displayed.
- Enter as many Sub-Master Station Numbers as you need.
- Each Sub-Master Station you enter can be scanned at the reader you are configuring.
- Any station ID that is not assigned a Sub-Master Station will have no effect when attempting to scan that station ID at the scanner/reader.
- Enter through all of the remaining upper case Station ID fields.
- There will be a second screen of lower case Station ID which you will also have to enter through.
- After entering the last field, respond to the question that appears.
- Only an answer of 'Y' will save the entries.
- Answering 'R' lets you review your changes.
- Answering 'S' will erase your changes and start over from the first entry.
- Your screen is now completed, and the new Station ID's will be available for use.
- You may now configure another reader, or press 'Esc' to exit to the Optifacts menu.
This article comes from the Optifacts SupportWeb.
