| Anchor | ||||
|---|---|---|---|---|
|
Search Optifacts User Documentation
| Live Search | ||||
|---|---|---|---|---|
|
Table of Contents (on this page)
| Table of Contents | ||||
|---|---|---|---|---|
|
Introduction
This document provides instructions for setting up ...bar code Reader ID numbers and Station ID numbers
Procedure
Configuring Tray Track Scanner / Bar Code Reader
This section assumes your scanner/reader is already programmed to work with Optifacts Tray Track. Optifacts Support will assist with configuring your scanner if needed.This Quick Note configures the stations you can scan with a given scanner/reader.
Custom Configuration
This applies to scanners attached to the Job Track interface only; it does not apply to scanners connected to a terminal. Refer to the Custom Configurations - Startup Interfaces document for full instructions.
Configuring Tray Track Scanner / Bar Code Reader
From the Optifacts main menu:
Type 7 - Tray Track
Select option #12and press enter.
Type 12 - Tray Track Configuration
Select option #3and press enter.
Type 3 - Reader ID & Station ID/Number Setup and press enter.
The Station Number Setup screen displays.
- Press 'a', 'b', 'c' or whatever letter has been designated for the reader you are about to update.
The following screen displays
- Enter the Sub-Master Station Number you want to add. As soon as this number is entered, the description for the number will be displayed.
- Enter as many Sub-Master Station Numbers as you need. Each Sub-Master Station you enter can be scanned at the reader you are configuring.Any Any station ID that is not assigned a Sub-Master Station will have no effect when attempting to scan that station ID at the scanner/reader.
- Enter through all of the remaining upper case Station ID fields.
There will be a second screen of lower case Station ID
which you will also have tothat displays.
- Press enter through all the fields.
After entering past the last field, respond to the question that appears.
- Are The Entries Correct (Y)es / (R)eview / (S)tart Over
Only an answer of 'Y' will save the entries.
- Type Y if correct and to save the data.
- Answering 'R' lets you review your changes.
- Answering 'S' will erase your changes and start over from the first entry.
Your screen is now completed, and the new Station ID's will be available for use.
- You may now configure another reader, or press 'Esc' escape to exit to the Optifacts menu.
Example
