Search Optifacts User Documentation
Table of Contents (on this page)
Introduction
This document provides instructions for setting up the Check Base Curve custom configuration.
This entry will enable Verify to check for nominal base change.
Uses no special settings.
Procedure
From the Optifacts main menu:
Type 3 - Editor Utilities and press enter.
Type 6 - Configuration Editor and press enter.
Type 6 – Edit Custom Configuration and press enter.
The Custom Configuration Editor displays.
- Press Q to Query to perform a search for the table shown below.
If the tables do not exist:
- Type A to add a new record.
- Enter all the information as shown in the diagram below.
- Press Escape to save the data.
- Type E to exit.
