Search Optifacts User Documentation
Table of Contents (on this page)
Introduction
This document provides instructions to set up a routing rule that will stop a job from automatically routing.
Procedure
Do not Route Lite-up
Routing Rule
Step 1 - Route Destination Editor
From the Optifacts main menu:
Type 3 - Editor Utilities and press enter.
Type 11 - Job Routing Menu and press enter.
Type 11 - Route Destination Editor and press enter.
The Job Routing Destination Control Manager screen displays.
- Create a new Routing Destination as shown in the following diagram.
- Press Escape to save the data.
- Type E to exit.
Step 2 - Route Conditions Control Editor
- Type 9 - Route Conditions Control Editor and press enter.
The Job Routing Condition Control Manager displays.
- Press Escape to save the data.
- Type E to exit.
Step 3 - Route Reason and Control Editor
- Type 8 - Route Reason and Control Editor and press enter.
The Job Routing Reason and Control Manager displays.
- Add a new entry as shown in the following diagram.
- Press Escape to save the data.
- Type E to exit.
