Search Optifacts User Documentation
Table of Contents (on this page)
Introduction
This document provides instructions for setting up bar code Reader ID numbers and Station ID numbers
Procedure
This section assumes your scanner/reader is already programmed to work with Optifacts Tray Track. Optifacts Support will assist with configuring your scanner if needed.
Custom Configuration
This applies to scanners attached to the Job Track interface only; it does not apply to scanners connected to a terminal. Refer to the Custom Configurations - Startup Interfaces document for full instructions.
Configuring Tray Track Scanner / Bar Code Reader
From the Optifacts main menu:
Type 7 - Tray Track and press enter.
Type 12 - Tray Track Configuration and press enter.
Type 3 - Reader ID & Station ID/Number Setup and press enter.
The Station Number Setup screen displays.
- Press 'a', 'b', 'c' or whatever letter has been designated for the reader you are about to update.
The following screen displays
- Enter the Sub-Master Station Number you want to add. As soon as this number is entered, the description for the number will be displayed.
- Enter as many Sub-Master Station Numbers as you need. Each Sub-Master Station you enter can be scanned at the reader you are configuring. Any station ID that is not assigned a Sub-Master Station will have no effect when attempting to scan that station ID at the scanner/reader.
- Enter through all of the remaining upper case Station ID fields.
There will be a second screen of lower case Station ID that displays.
- Press enter through all the fields.
After entering past the last field, respond to the question that appears.
- Are The Entries Correct (Y)es / (R)eview / (S)tart Over
Only an answer of 'Y' will save the entries.
- Type Y if correct and to save the data.
- Answering 'R' lets you review your changes.
- Answering 'S' will erase your changes and start over from the first entry.
Your screen is now completed, and the new Station ID's will be available for use.
- You may now configure another reader, or press escape to exit to the Optifacts menu.
Example
