Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Anchor
top
top

Search Optifacts User Documentation

Live Search
spaceKeyOPPUB
placeholderEnter search keyword(s) here


Table of Contents (on this page)

Table of Contents
outlinetrue
indent20px
styleBulletnone

Introduction

This document provides instructions for the Frame Trace and Frame to Come Lookup process when the frame trace is done after the job has started.

Procedure

Verify that Auto-assign Bin is Turned on

The following custom configuration must be enabled.

Job without Frame

  • The job gets keyed as normal without the frame.
  • Lenses are picked and sent into surfacing.
  • The frame comes from Doctor and gets sorted in the Frame Room.
  • Frame Room clerk goes into Frame to Come Lookup menu 7-17 and “checks in” the Frame.
  • The label gets printed and placed on the bag/box/case.
  • Checked-in Frames get sent to the Frame Manager.

Job with Frame

  • The job gets keyed as normal.
  • Frame Room or Rx OE goes into Frame to Come Lookup menu 7-17 and “checks in” the Frame.
  • The label gets printed and placed on the bag/box/case.
  • Lenses are picked and sent to the surface department.
  • Frames get taken to the Frame Manager

Frame Manager

  • Frame and Lenses are “Married” after the job is done in Surface/AR using the scanning protocol.
  • The tray gets sent to the Tracer for Frame Tracing.
  • The job moves on to the finishing department.

To view and download these instructions as a PDF file, click on the following document image.

View file
nameFrame Trace After Job Start.pdf
height250