Click here to view the Machine Interface, Optifacts Programs, Lab Equipment & Scanners menu.

Click here to view the complete Optifacts User Documentation Index.

Click here to contact us.

Introduction

This document provides instructions for setting up bar code barcode Reader ID numbers and Station ID numbers

Procedure

This section assumes your scanner/reader is already programmed to work with Optifacts Tray Track. Optifacts Support will assist with configuring your scanner if needed.

Custom Configuration

This applies Applies to scanners attached to the Job Track interface only; it does not apply to scanners connected to a terminal. Refer to the Startup Interface Custom Configurations document for full instructions.Image Removed.

From the Optifacts main menu:

Select Option 3 – Editor Utilities and press Enter.

Select Option 6 – Configuration Editor and press Enter.

Select Option 6 – Edit Custom Configuration and press Enter.

The Custom Configuration Editor displays.

• Press “Q” to Query.
• Ensure that the table below exists.

If the table does not exist:

• Press “A” to add a new record.
• Enter all the information as shown in the diagram below.
• Press Escape to save the data.
• Press “E” to exit.

Image Added

Configuring Tray Track Scanner / Bar Code Reader

From the Optifacts main menu:

Type Select Option 7 - Tray Track and press enterEnter.

Type Select Option 12 - Tray Track Configuration and press enterEnter.

Type Select Option 3 - Reader ID & Station ID/Number Setup and press enterEnter.

The Station Number Setup screen displaysis displayed.Image Removed

Image Added

• Press 'a', 'b', 'c' “a,” “b,” “c,” or whatever letter has been designated is for the reader you are about to update.

The following screen displays.Image Removed

Image Added

• Enter the Sub-Master Station Number you want to add. As soon as this you enter the number is entered, the description for the number will be is displayed.
• Enter as many Sub-Master Station Numbers as you need. Each Sub-Master Station you enter can be scanned at the reader you are configuring. Any station ID that is not assigned a Sub-Master Station will have no effect when attempting to scan that station ID at the scanner/reader.
• Enter through all of the remaining upper case Station ID fields.

There will be a second screen of lower case Station ID that displays.

• Press enter Enter through all the fields.

Image Removed

Image Added

After entering past the last field, respond to the question that appears.

Are The Entries Correct (Y)

Yes / (R)

Review / (S)

Start Over

Only an answer of 'Y' ‘Y’ will save the entries. 

Type Y
• Press “Y” if correct and to save the data.
• Answering
'R'
• “R” lets you review your changes.
• Answering
'S'
• “S” will erase your changes and start over from the first entry.

Image Removed

Image Added

Your screen is now completedThe form is complete, and the new Station ID's will be IDs are available for use.

• You may now configure another reader , or press escape Escape to exit to the Optifacts menu.

Example

Image Removed

Image Added

To view and download these instructions as a PDF file, click on the following document image.

Click here to return to the top of the page.