to be released….
Printer Routing
See Setting Up Routing Rules - Rx-Universe - Confluence (atlassian.net) for details
The condition called "Sphere <=" has been renamed to "All Spheres <=" to make the behavior more clear.
Added new condition "Either Sphere <="
Added new condition “Lens Stock Status =“
Added new condition “Frame Stock Status =“
API
Fixed an issue where GET/frames/trace failed when the requested trace had > 1000 points
Work Tickets
New labels have been added that can be used on the “User defined work tickets”. The new labels report the last lens breakage and the number of times that the order went through a lens breakage. The Labels are _RTBKG and _LTBKG
Blank Selection
The existing CRIB safety allowance fields (System Settings:Surf1 and Setup:Lens Styles) has been split into two separate fields, one for finished blanks and a different one for semi finished blanks
Tracings
The tracing maintenance program has been enhanced to allow for separate size adjustments for the right/left eyes. Note that left eye adjustment is only available if there are trace points in the left eye.
When auto-attaching a trace, if the order had a trace already, keep the original trace parameters.
Remote Orders
When a remote order is received that has bad addon codes, the order will be made un-valid and the bad codes placed in the error messages.
Order entry
When pressing “Calcs” on an order, the addon codes are now verified. If any are bad, the order will be placed un-valid and the incorrect codes displayed in the messages.
Digital processing
The following labels can now store values received from the digital processing CTHNP, CTHNA, CTHKP, CTHKA and PTPRVA.
Devices
VCA devices. The following labels have been added for use by devices, CTHNA, CTHKP, CTHKA. These labels along with CTHNP and PTPRVA can return values for digital or toric type order.
Tag FCRV is now sent to Horizons digital as part of the BRS request
VCA devices - support for SAFELENS has been added, if an order is marked as using safety thickness, then SAFELENS=1, otherwise SAFELENS=0 (per the DCS standard)
VCA tracer - when auto-attaching a trace, if the exiting trace on an order is set to calcs only, the trace being attached is saved as an INV# trace. The frame type was not being cleared when it should have. If the original trace on the order is not an “INV#” or “FTD” trace, keep the existing trace parameters when saving the attached trace as an “INV#”.