Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 7 Next »

Search Optifacts User Documentation


Table of Contents (on this page)

Introduction

This document provides instructions for the Frame Trace and Frame to Come Lookup process when the frame trace is done after the job has started.

Procedure

Verify that Auto-assign Bin is Turned on

The following custom configuration must be enabled.

Job without Frame

  • Job is keyed as normal without the Frame.
  • Lenses are picked and sent into surface.
  • Frame box comes from Doctor and sorted in the Frame Room.
  • Frame Room goes into Frame to Come Lookup menu 7-17 and “checks in” the Frame.
  • Label is printed and placed on bag/box/case.
  • Checked in Frames are sent to the Frame Manager.

Job with Frame

Frame Manager

  • Frame and Lenses are “Married” after the job is done in Surface/AR using the scanning protocol.
  • Tray is sent to the Tracer for Frame Tracing.
  • Job moves on to Finishing


  • No labels