Released 18 March 2016
(Includes all changes since version 6.47.00)
Devices
Fixed an issue with the digital processor. When 10 orders are on hold, it continually goes through those 10 orders and never sends any valid orders (version 6.47.01).
When feasibility is requested for Shamir, send DOSDF=N. Also, allow LDPATH=?, because that is what is returned sometimes when DOSDF=N, or _PRECAL=1 (version 6.47.02).
For VCA devices, some tracers do not send DBL with the trace. If an order uses a trace that has DBL=0, then the DBL on the order will be sent to the device (version 6.48.00).
Digital Surfacing
When entering a digital job, the "Filter lenses by availability" now causes the materials, etc., to be filtered based on the VCA label table (for designs where the LNAM is determined from the VCA label table), or from the inventory availability for the alias lens style (version 6.48.00).
The monthly Essilor Digital report can now be automated in Rx-Universe. For details, please see Essilor Digital Report.
When a digital job has an error (or is otherwise not manufacturable), this is indicated on the customer service screen with a "#" characters, as follows:
Order Entry
When the tray number is changed on the Order Entry screen, calcs are required so that the OMGEN record gets updated (version 6.47.02).
Modification to order entry. When a job is completed, delete the tray number record from the GEN record (version 6.47.02).
For Rx-Site, a new "material description" table has been added. This allows the lab to have specific descriptions for combinations of material, tint and treatment to be shown to Rx-Site users. For complete details, please see Rx-Site Material Descriptions.
A new personalization option for FWD (intermediate working distance) has been added - personalization options are described in Personalization Options.
A remake now shows the remake information (original order number and the remake reason) on the customer service screen (version 6.48.00) as follows:
The length of the wearer’s initials has been increased from 4 characters to 10 characters (version 6.48.00).
When sending orders electronically to Rx-Universe, the sending party can specify the OPC of the blanks that are to be used. If these blanks cannot be found, or cannot be used (because of thickness, curveout, etc), or if the blanks different in design from the design that was requested (requesting a SV design and specifying OPCs for Flat Top blanks, for example), the order will be saved unvalid for manual intervention. When the OPCs are specified in the remote file, blank selection will NOT be attempted by Rx-Universe (version 6.48.00).