Page Comparison

OMICS Software Inc. assumes no responsibility nor will it provide support, configuration & maintenance on the proposed infrastructure below. 

The information given below is only intended as general guidance on "how to" install and configured these solutionsthis remote Thin Client.

With RX-Universe it is possible to have a Thin Client session connecting from the outside a remote offsite location via the Internet. It does require a few configurations that may require the local IT support most cases this will require the involvement of the clients local IT provider to help with this.

Some client may require VPN (Virtual Private Network) Tunnel to meet their current security compliancecompliances, if so they will need to consult with their current IT provider for the best VPN solutions. 

If VPN is not necessary we can get a remote thin client configured to access via Internet Protocol using specific port communication. (Note: This will also still require the end client to consult with their current IT provider to setup this.)

 The information given below is only intended for guidance on how to install this.  

Requirements:

1. A Public Static IP Address or alternatively a Dynamic DNS Service that automatically updates to the Public IP (ie:WWW.DYNDNS.ORG)
2. A Static IP Address on the RX-Universe Server
3. Configure Configuration of the Firewall/Router to forward port in both location to allow inbound and outboubd traffic & port forwarding port# 5640 to the IP of the RX-Universe Server
4. Also if applicable open Incoming out outgoing & Outgoing traffic on Firewall or the RX-Universe Server

In the example below we are assuming that the Public IP provided by the ISP is "142.166.201.203" and that the RX-Universe Server is setup on a static IP of "192.168.1.50"

Image Removed

 Image Added

Installing using VPN

1. Install and configure the VPN client at the remote site, confirm you can connect correctly Client should have a functioning VPN enable appliance/router along with the VPN Client connection created on his remote pc. The VPN connection should be tested before attempting the next steps.
2. Install RX-Universe Thin Client (click → here for instructions)
3. Change the IP address in the Thin Client to the RX-Universe ServerServer (do not change the port #)

Installing using Internet Protocol

1. Install and configure the RX-Universe Thin Client on the remote

...

1. PC (click → here for instructions)
2. Configured the properties of the RX-U Thin client to connect to the PUBLIC IP or Dynamic DNS Name. (do not change the port #)

Image Added