Nucleo Block Selection - For Nucleo blocks, the lab can define the block pieces that are available, and when each should be used.
Block selection for Nucleo Grid
...
The “Block” column is just an identifier for the block.
...
A lens with a true curve of 5.92 in 1.53 index would have a radius of curvature of 89.527.
...
Diameter selection for Nucleo Grid
...
The “Diameter selection” grid is used to “group” blocks already used, and allows selection of a block in the correct group based on the crib diameter of the job.
...
ART Block Selection - For ART blocks, the lab can define the block pieces that are avaliableavailable, and when each should be used.
Block selection for ART Grid
...
The “Block” column is just an identifier for the block.
...
A lens with a true curve of 5.92 in 1.53 index would have a radius of curvature of 89.527.
...
Diameter selection for ART Grid
...
The “Diameter selection” grid is used when “Allow Cribbing of ART Blocks” is checked. This is used to “group” blocks already used, and allows selection of a block in the correct group based on the crib diameter of the job.
...
The cribbing allowance cannot be less than 1.0
Missing Information:
BLKCEHI
BLKDMBlock repick tolerance - This variable is used when an order is recalculated. It compares the order CRIB diameters (before and after) the calculation to determine if the new which Nucleo/ART block to use. If the difference between the two cribs is greater than the tolerance, then the new block is used for the order, otherwise, the order keeps the existing blocks. Note that if the block RNGDM changes, then the new block will be selected.