Anchor

	top
	top

Search Optifacts User Documentation

Live Search

spaceKey	OPPUB
placeholder	Enter search keyword(s) here

Table of Contents (on this page)

Table of Contents

indent	20px
style	Bullet

Introduction

This document provides instructions for the Frame Trace and Frame to Come Lookup process when the frame trace is done after the job has started.

Procedure

The following custom configuration must be enabled.

Refer to the Custom Configuration section in the Frame Management Setup (Frame to Come/Frame Marry/Label Printing) document for full instructions.

Image Modified

Job is keyed as normal without the Frame.
Lenses are picked and sent into surface.
Frame box comes from Doctor and sorted in the Frame Room.
Frame Room goes into Frame to Come Lookup menu 7-17 and “checks in” the Frame.
- Refer to the Receive Frame and Assign To Bin document for full instructions.
Label is printed and placed on bag/box/case.
- Refer to the Refer to the Label Printing section in the Frame Management Setup (Frame to Come/Frame Marry/Label Printing) document for full instructions.
Checked in Frames are sent to the Frame Manager.

Job is keyed as normal.
Frame Room or Rx OE goes into Frame to Come Lookup menu 7-17 and “checks in” the Frame.
- Refer to the Receive Frame and Assign To Bin document for full instructions.
Label is printed and placed on bag/box/case.
- Refer to the Refer to the Label Printing section in the Frame Management Setup (Frame to Come/Frame Marry/Label Printing) document for full instructions.
Lenses are picked and sent into surface
Frames are taken to the Frame Manager

Frame and Lenses are “Married” after the job is done in Surface/AR using the scanning protocol.
Tray is sent to the Tracer for Frame Tracing.
Job moves on to Finishing