Anchor | ||||
---|---|---|---|---|
|
Search Optifacts User Documentation
Live Search | ||||
---|---|---|---|---|
|
Table of Contents (on this page)
Table of Contents | ||||
---|---|---|---|---|
|
Introduction
This document provides instructions for the Frame to Come Lookup process when the frame trace is done after the job has started.
Procedure
Verify that Auto-assign Bin is Turned on
The following custom configuration must be enabled.
- Refer to the Custom Configuration section in the Frame Management Setup (Frame to Come/Frame Marry/Label Printing) document for full instructions.
Job without Frame
- Job is keyed as normal without the Frame.
- Lenses are picked and sent into surface.
- Frame box comes from Doctor and sorted in the Frame Room.
- Frame Room goes into Frame to Come Lookup menu 7-17 and “checks in” the Frame.
- Refer to the Receive Frame and Assign To Bin document for full instructions.
Procedure
From the Optifacts main menu:
Type
coming soon.....- Label is printed and placed on bag/box/case.
- Refer to the Refer to the Label Printing section in the Frame Management Setup (Frame to Come/Frame Marry/Label Printing) document for full instructions.
- Checked in Frames are sent to the Frame Manager.
Job with Frame
- Job is keyed as normal.
- Frame Room or Rx OE goes into Frame to Come Lookup menu 7-17 and “checks in” the Frame.
- Refer to the Receive Frame and Assign To Bin document for full instructions.
- Label is printed and placed on bag/box/case.
- Refer to the Refer to the Label Printing section in the Frame Management Setup (Frame to Come/Frame Marry/Label Printing) document for full instructions.
- Lenses are picked and sent into surface
- Frames are taken to the Frame Manager
Frame Manager
- Frame and Lenses are “Married” after the job is done in Surface/AR using the scanning protocol.
- Tray is sent to the Tracer for Frame Tracing.
- Job moves on to Finishing