| Anchor | ||||
|---|---|---|---|---|
|
Search Optifacts User Documentation
| Live Search | ||||
|---|---|---|---|---|
|
Table of Contents (on this page)
| Table of Contents | ||||
|---|---|---|---|---|
|
Introduction
This document provides instructions to set up the routing rule for Supplied (enclosed) lens orders. This routing rule does all the things needed so that we don't decrement inventory and we allow edging files to be created without the demand for inventory verification.
Procedure
The lite-up called SUPPLIED LENS has num 0 and bit 16. We have this one hard-coded to flag items in sales analysis etc. so we don't attempt to count this lens as one that's processed from inventory. This should be lit up on every Supplied Lens (enclosed) job.
Route Destination Editor
From the Optifacts main menu:
Type 3 - Editor Utilities and press enter.
Type 11 - Job Routing Menu and press enter.
Type 11 - Route Destination Editor and press enter.
The Job Routing Destination Control Manager screen displays.
- Create a new Routing Destination as shown in the following diagram.
- You can c all the site whatever you want, like Enclens, Suplens, Verify or Here as shown in our example. This is a fake routing rule that goes no where (note it's not a local routing rule).
- Make sure to use E for external in the protocol of 3-11-11 Route Destination Editor.
- Press Escape to save the data.
- Type E to exit.
Route Conditions Control Editor
- Type 9 - Route Conditions Control Editor and press enter.
The Job Routing Condition Control Manager displays.
- Type the Condition ID and press enter. In our example we are using "SUPPLIED LENS" to indicate what the rule is being used for.
- Type the Destination Site and press enter. This is the same destination site as entered in menu 3-11-11.
- Press Escape to save the data.
- Type E to exit.
Route Reason and Control Editor
- Type 8 - Route reason Reason and Control Editor and press enter.
The Job Routing Reason and Control Manager displays.
- Add a new entry as shown in the following diagram.
- Type priority 1 and press enter
- Type the Condition ID 1 pressing enter past each field.Type the same destination site you used in and press enter. This is the same Condition ID that was setup in menu 3-11-11 and press enter9.
- Type E in the Uncut field to indicate that if this rule applies only to edged work, and press enter.
- Leave blank for both edged and uncut work.
- Type S in the Finished Only field to indicate that if this rule applied applies only to semi-finished work, and press enter.
- Leave blank for both finished and semi-finished lenses.
- On the 2nd screen, enter a blank diameter from 98.0 through 99.0
- Press Escape to save the data.
- Type E to exit.