Versions Compared

Old Version 1

changes.mady.by.user Lori Dickson

Saved on

compared with

New Version 2

changes.mady.by.user Lori Dickson

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Anchor
top
top

Click here to view the Job Routing menu.

Click here to view the complete Optifacts User Documentation Index.

Click here to Contact us.

Search Optifacts User Documentation

Live Search
spaceKeyOPPUB
placeholderEnter search keyword(s) here


Table of Contents (on this page)

Table of Contents
indent20px
styleBullet

Introduction

This document provides instructions to set up the routing rule for Supplied (enclosed) lens orders. This rule will allow the lab to run the supplied lens job through verification to create the necessary edging file, without decrement to inventory and still be able to edge the lenses.

Procedure

From the Optifacts main menu:

Lite

routing rule does all the things needed so that we don't decrement inventory and we allow edging files to be created without the demand for inventory verification.

Procedure

The lite-up called SUPPLIED LENS has num 0 and bit 16. We have this one hard-coded to flag items in sales analysis etc. so we don't attempt to count this lens as one that's processed from inventory.


This

 This should be lit up on every Supplied Lens (enclosed

job.    Then a routing rule called whatever you want. Like EncLens

) job.

From the Optifacts main menu:

Type 3 - Editor Utilities and press enter.

Type 11 - Job Routing Menu and press enter.

Type 11 - Route Destination Editor and press enter.

The Job Routing Destination Control Manager screen displays.

Image Added

  • Create a new Routing Destination as shown in the following diagram.
    • You can c all the site whatever you want, like Enclens, Verify or Here.
  This
    • This is a fake routing rule that goes no where (note it's not a local routing rule).  
 Use
    • Make sure to use E for external in the protocol of 3-11-11 Route Destination Editor.
image.pngImage Removed
In menu  3-11-8 add something like this using priority 1 and  Image Added
  • Press Escape to save the data.
  • Type 8 - Route reason and Control Editor and press enter.

The Job Routing Reason and Control Manager displays.

Image Added

  • Add a new entry as shown in the following diagram.
  • Type priority 1 and Condition ID 1 pressing enter past each field.
  • Type  the same destination site you used in 3-11-11
image.pngImage Removed
This routing rule does all the things needed so that we don't decrement inventory and we allow edging files to be created without the demand for verify
  • and press enter.
  • Type E in the Uncut field to indicate that this rule applies only to edged work, and press enter.
  • Type S in the Finished Only field to indicate that this rule applied only to semi-finished work, and press enter.
Image Added
  • Press Escape to save the data.
  • Type E to exit.




Click here to return to the top of the page.