Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Re-calc job on auto attach - Checking this box will cause Rx-Universe to recalculate the job when a frame is traced and automatically attached to the job. This includes digital jobs, in which case the job will be re-submitted to the digital calculator.

A or B tolerance for recalc - This allows a lab to only recalculate an order based on the size difference between the A or the B measurement. The current trace attached to the order or the box measurements will be compared to the A and B measurements from the trace being attached. If the difference in either the A or the B is greater or equal to the tolerance level, then the recalc will occur. A tolerance set to “0.0” will always cause the recalc to occur.

Print WT on auto attach recalc - When a frame is traced with a tray number and automatically attached to an existing job, the job will be recalculated if the trace measurements differ from the box measurements by more than 0.50 mm, or if the frame type changes on the order. Checking this box will cause a work ticket to be printed when the trace is attached (note that if using the XML user-defined work ticket, this option requires the job tracking module to be active).

...

This checkbox now allows a lab to choose that new, unrecognized TCP/IP devices will NOT have entries automatically created in the device table.

Check the device IP when communicating - When this is checked, TCP device sessions will use the IP of the device that’s communicating to find the correct entry from the device parameters for the workstation device session that is started.

If no match is found, the program will either create a new device parameter (depending on the setting of the “Do NOT auto create NEW TCP/IP devices”) or the communication will time out with nothing sent to the requesting device.

...

Crib group w/o AR coating - This allows the lab to select a crib group for jobs which d not have AR on them.

...