Page Comparison

...

Array designs must be set up to use a base curve chart (chart AY is pre-created for convenience).  Designs have limited decentrationArray designs can now be decentered by Hoya, so should be set up similar to the following:
Image Removed
Image Added

Checking the "Center Design on Frame" option will instruct the Hoya calculator to optimize decentration, by sending "_OptimizeDecenterFlag=1" in the LDS file.  Of course, this label must be included in the LDI file in order to be included in the LDS file.

Amplitude and Summit designs

...

The Hoya calculator also requires _CTO=1 to be sent in the LDS file in order to o360pxbtain thickness results back.  Set this up in the same screen, two labels to be set up device setup under VCA Over-rides, as follows:
Image Removed
Image Added

_CTO=1 instructs Hoya to return thickness information, and _OUTPUTFORMAT=1 instructs it to return an SDF file in VCA-standard structure.