Calculations
A new option has been added to the Surf1 tab under "System Settings" - "Min ET @ Crib Diam". This allows a minimum thickness to be set, system-wide, at the crib diameter of a job, which protects against knife-edge blanks cutting into soft tools used in cut-to-polish polishers. Note that increasing the thickness of a blank to meet the minimum ET at the crib diameter will increase the thickness of the edged lens (version 6.41.00).
Digital Surfacing
A checkbox has been added to the device setup to indicate a DLM (digital lens mapper). When used with an IOT Camber design, the following labels will be mapped to the values sent in the second column, from IOT:
VCA Label | Label from IOT |
---|---|
BCERIN | _BCERIN |
BCERUP | _BCERUP |
KPRVM | _KPRVM |
KPRVA | _KPRVA |
LDPATH | _LDPATH2 |
If the checkbox is checked, and requests BCERIN, for example, if _BCERIN exists in the LMS file returned from IOT, the value associated with _BCERIN will be sent as the value for BCERIN, for this device only. This allows for a Camber design to be blocked "upside down", and for the correct values to be sent to the DLM (version 6.41.00).
Device Interfaces
VCA over-rides have been added to the Addon table. As with lens styles, devices, accounts, and orders, values for specific VCA labels can be specified for specific addon codes. For example, to set label CXFILMTYP for a specific hydrophobic AR:
Inventory
The allowable values for Min and Max Supply Days have been expanded to 9999 from 99 for Inventory Mass Maintenance (version 6.40.00).
The maximum quantity that can be entered for the Min and Max quantities in mass maintenance has been changed to 499999 (version 6.41.00).
Reporting
A checkbox has been added to the Orders1 tab in System Parameters, "Print patient name on AR envelope". This can be unchecked to meet requirements of specific countries regarding privacy (ie HIPPA) (version 6.41.00).
Manufacturer Reporting
The Shamir report has been changed to match Shamir's new format, reporting on redos, farmouts, and Glacier Plus AR (version 6.41.00).
The Essilor report has been modified to allow it to be sent via ftp as well as by email. In addition, it can be run automatically as part of the monthend, using new checkboxes on the "Dayend" tab under "System Parameters". Columns for new products "Varilux Comfort W2+, W2+ Fit and W2+ Eyecode", and for "Varilux Physio W2+, W2+ Fit and W2+ Eyecode" have been added (version 6.41.00).