VisionWeb communications can be done via VPN or via FTP.  The newer FTP method is the easiest to setup.  

The method used is dependent on the new "Use FTP as communication method" flag.

Now that we have both a VPN and an FTP method, we can test L2L transmissions between the two.   This is done using the Vision web supplier ID (see below) in the "Remote Lab" maintenance screen.

To send orders to the FTP site, set the supplier Id to "3702".   To send orders to the VPN (MQ series) use supplier ID "3701" (this is our original lab Id with Visionweb.   When using the lab-to-lab transmission, set the lab ID to the one you want the orders to go to (either FTP or VPN).

Image Added

VisionWeb using FTP

...

If you want to test the VisionWeb FTP communications, use the following RxUniverse test account.

FTP User Id  omicstest

FTP User password  y36AbINd

The FTP communication method creates a script that is run by the Winscp program.  The script that's created is called VWEBFTP.xxx where xxx is replaced by the workstation ID. 

VisionWeb using VPN

VisionWeb requires two pieces of software to be installed on the computer running the Rx-Universe Remote Processor session (usually the server).  These two pieces are the "Cisco VPN Client" and the "IBM WebSphere" connectors.

...