...
The particular block pieces that are available, with their characteristics, and rules on when to use the block, must be set up in Rx-Universe, under "Setup", "System Settings", then the "Nucleo" tab or the "Art" tab.
The ART and Nucleo blocks can be set up separately. For each block piece:
...
To pick a block piece, the "true curve" of a blank will be converted to radius of curvature, that radius of curvature compared to the "min r" and "max r" values for each block, and the block picked that includes the radius of curvature of the blank. In the case of ART Premium blocks, since each block radius comes in various diameters, the block selected will be based on the required cribbing. The cribbing required will be checked against the "Diameter selection" table for ART Premium and the "Group" will be used to select the correct block diameter along with the radius when determining the block to use..
For example, if a blank has a true curve of 5.92, in 1.53 index, that blank has a radius of curvature of 89.527. Comparing that to the "min r" and "max r" of the block list, block piece 5 will be selected.
...