...
- if credit rating is "B" (Use Limit), and the customer balance exceeds the credit limit, a warning is displayed during manual OE. No effect on electronic orders.
- if credit rating is "C" (COD only), a warning message is displayed during manual OE. No effect on electronic orders.
- if credit rating is "D" (no order shipping when over limit), a warning message is displayed during manual shipping if the customer balance exceeds credit limit
- if credit rating is "E" (no new orders when over limit), if the customer balance exceeds the credit limit, an error is displayed during manual OE, and an electronic order will be saved unvalid
Digital and Device Interfaces
When Single Vision designs that require a fitting height were sent from Vision Web, if the job had been entered with both a distance and a near PD, and the fitting height NOT entered in VisionWeb, Rx-Universe would erroneously take the NPD as the fitting height. This has been corrected.
For lenticular lenses manufactured on a Schneider generator, if the device identifies itself with a vendor code = "SOM", then the carrier curve is sent in FRNT. Normal behaviour is to send the true curve in FRNT and the carrier curve in IFRNT, but Schneider does not use IFRNT.
Order Entry
When specifying a specific flat top blank in a remote file, using OPC, for an uncut job without frame measurements, the default decentration was not calculated.
...