...
The labels GBASE and GCROS in the VC interface were being sent to the generator as the padded (but not rounded) tool curves. This could result in slight differences between the curve on the lap and the curve cut by the generator, so GBASE and GCROS have been changed to be sent as the rounded tool curves. Note that GBASEX and GCROSX, used by cut-to-polish equipment, were not affected by this change.
In August 2018, changes were made to always send LDDR* and LDNR* values to a device identified as a mapper, by sending Rx values as appropriate when compensated values do not exist. These changes were not implemented for LDDRCYL through an error, so LDDRCYL is correctly changed in this version.
Remote Orders
Fixed an issue with the VisionWeb interface, it would try to write an entry to the error log, but the error log was not turned on.
...