...
A change has been made to give preference to the amount of prism on a blocking ring before considering crib diameter, for blocking rings used with the Satisloh Micro-Blocker.
When LMATID is set for a National Optronics device, different codes are sent if the lens has AR on it. When job tracking is used, and the job scanned when AR is applied, this works well, as the code is only changed if AR is already present on the lens. When job tracking is not installed, a change has been made to assume AR is on the lens, so that the AR code is sent to the edger. Even if AR is applied after edging, the only effect is to slow the edger down a bit when it isn't strictly necessary. However, this change prevents NOT using the AR macro when AR is, in fact, already on the lens.