...
In the case of a digital re-calculation, If a digital vendor selects the blanks to use, then the modified front curves, if any, stored on the order will be cleared if the blanks selected are not the same.
Device Interface
One the “Edger” tab of a VC device, a new checkbox has been added “Use the trace supplier for the FMFR label”. If checked, when this device requests FMFR, the value from the trace supplier will be sent (assuming it is not blank), rather than the frame manufacturer.
Work Tickets
The labels for LENSQOH, STK_STAT_L and STK_STAT_R did not always give the correct values. This has been corrected.
...