...
It is now possible to interface with a digital calculator(s) directly from Order Entry. For complete details, please see 1.5 Doing Digital Calculations From Order Entry (version 6.45.00).
...
New options are available to allow generating prism for digital jobs on equipment that supports that - for details, see 1.2 Prism on Digital Designs (version 6.45.00)
...
A new option has been added to the device setup to allow sending any prism that wasn't blocked, to a generator for digital jobs. When checked, this causes digital jobs to be run the same as toric jobs; the maximum amount of prism supported by the blocker will be blocked, and any remaining prism sent to the generator. If a generator does not support prism on digital jobs, this option should be UNchecked:
If not all prism can be blocked, and the generator does not allow GPRVM to be sent for digital jobs, then an error will be raised when the job is requested by the generator, and the job not manufactured. This will prevent jobs from being manufactured without the correct amount of prism.
Zeiss Digital with Schneider Equipment and Alternate Interface (version 6.44.05)
...