Release date: est Sept 2015
(Includes changes since 6.44.00)
Digital Surfacing
Digital Interface From Order Entry (version 6.45.00)
Interfaces with digital calculators can now be done either directly from the order entry screen, or using the Digital Processor. Previous versions of Rx-Universe always used the Digital Processor to communicate with digital calculators.
...
For Zeiss digital jobs, if the option "Print Zeiss Digital Ticket at Digital Processor" on the Digital tab under System Parameters is checked, then the Zeiss Digital Ticket will be printed when the LMS file is received back from Zeiss (within Order Entry).
Generating Prism for Digital Jobs (version 6.45.00)
A new option has been added to the device setup to allow sending any prism that wasn't blocked, to a generator for digital jobs. When checked, this causes digital jobs to be run the same as toric jobs; the maximum amount of prism supported by the blocker will be blocked, and any remaining prism sent to the generator. If a generator does not support prism on digital jobs, this option should be UNchecked:
...
Note that when using this option, care must be taken not to trace the right eye of one frame, and the left eye of a different frame, for the same tray at slightly different times (for doing so will cause the eyes to be combined into a single trace!) (version 6.45.00).
Support has been added for the Satisloh Micro-Blocker - for complete details, please see Satisloh Micro-Blocker (version 6.45.00).
Reports
The Stock Costing Report was modified to use the standard cost (vendor cost 1) instead of the average cost when determining the value of excess stock (version 6.44.02).
...