...
Both the ELLH maximum and ELLH percentage of crib, operate the same as the system default. The largest of the resulting values become the acceptable minimum for the device.
Modifying an ELLH valuvalue
The ELLH value can be set by the user only on "Uncut no frame" jobs. This is accomplished via the “F12 Surf opt” button on the order maintenance screen.
...
Crib and ELLH suppression can be controlled on each job. The ELLH value can also be set on an order in the ‘User ELLH” fields. The User ELLH value will be verified when sent to the device to ensure that it still conforms to the limits required by the override the device settings (limits) and send the User ELLH to the device.
The fields “Actual ELLH” and “Actual Crib Diameter” contain the actual values that were sent to a generating device. ; if these values are changed on the generator device, the device will not send back these new values to these fields in Rx-Universe.
The crib and ELLH values can also be viewed in the “Devices fields” screen.
...