(Includes changes since 6.42.00)
Digital Interfaces
A change was made to not send CRIB/ELLH in the LDS file to Crossbows, but it actually suppressed CRIB/ELLH in all device packets for Crossbows. This has been corrected (version 6.42.01).
When OPCs are returned in an LMS file that are not active, the message on the work ticket should show the OPC of the product that is not active. It did this for the right eye but not for the left eye. This has been corrected (version 6.42.02).
For Essilor Digital, the block returned for full offering lenses was not being printed on the work ticket. This has been corrected (version 6.42.03).
For INDO Digital jobs, a modified PD may be sent back in the LMS file. This PD was not being used for the CAD2000 blocker since version 6.41.00 (version 6.42.03).
A change was made to not allow the value of the FED label to be smaller than the A (version 6.42.04).
Changed the formatting of LDADD to be the same as ADD as well as use the "Add with + and leading zero" checkbox (version 6.42.05).
Increased the incoming file size from 150,000 bytes to 500,000 bytes for a DEO file with SDF and DZY data in it (version 6.42.06).
Expanded the size of the SDF file from 1000 bytes to 5000 bytes to handle the DXZ lines (version 6.42.06).
A change was made to include TRCFMT=0 in the LDS file when calculating an uncut for Essilor (version 6.42.08).
Job Tracking
Under certain circumstances, when a work ticket was printed, the job history was not being updated (version 6.42.02).
Reversed change to job history as it was causing the job tracker to not process entries (version 6.42.07).
Remote Orders
If a remote (electronic) file uses _TRACE to specify a trace, and then sends FTYP and/or ETYP after _TRACE in the raw file, the trace was not being corrected attached to the order. If the FTYP or ETYP was sent before the _TRACE record, the FTYP or ETYP setting (which can affect thickness) was being lost. These problems have been corrected (version 6.42.03).