Define Block Pieces and Selection Rules
Nucleo/ART blocks have some additional parameters that must be set up in Rx-Universe. The block and blank together need/use the following fields:
The block pieces and when to use them must be set up under "Setup", "System Settings", then the new "Nucleo" tab.
The ART and Nucleo blocks can be set up separately. For each block piece:
- the "Text" column specifies the text that will be printed on the work ticket.
- the "radius" field is the radius curvature of the inside block piece
- the "min r" field is the minimum radius of curvature of the blank for this block piece
- the "max r" field is the maximum radius of curvature of the blank for this block piece
- the BLKCEHI is the height of the
- the "diam" field is the physical diameter of a new (unused) block piece
...